The information displayed in the first part is merely descriptive and shows previously assigned data:
•Code: the path of the resource that you are editing is displayed
•Type: shows the resource type
•Number: indicates the ordinal number that identifies that resource in case others of the same type coexist.
The user must enter the following information:
•Name: description of the resource you are editing.
•Driver: fixed COURTYARDLD
•Configuration:
✓ The logo generator is configured to indicate how you want the logo to be configured.
✓Indicate the associated DSK: Indicate if the DSK is internal (INSIDE) or if one of those in the resources (previously configured) must be associated.
(Warning: you need to configure DSKs first because only installed DSKs are displayed)
•Preset/Take Mode: Some devices can pre-load the logo before sending it ON AIR to speed up the operation at the moment of the take; this possibility can be exploited by using the device in preset/take mode instead of the standard mode. The preset/take mode is suggested only if a commutation is used for each event. Otherwise, the results could be unpredictable.
Serial connection wire: RS232 pin to pin (male-female)
Courtyard Logodog resource editor - User
After indicating which user and which software the resource has to be installed for, you have to set other data:
Com port setting:
The VTR can be controlled directly through a serial connection (in this case, you have to set the com number) or through UDP with the ETERESARVAJI software (in this case, you have to indicate the IP address of the PC that EtereSarvaji runs on and the Local Port which EtereSarvaji uses.
Com n. - Indicate several PC com to which the machine is connected.
Com configuration:
The com is configured with the following default values:
✓Baud: 19200
✓Parity: None
✓Stop bits: 1
✓Data bits: 8
422:
✓Device (out)- Indicate the no. of the device to be installed when you open the resource.(-1=not installed)
✓Controller (in)- Indicate the no. of the controller to be installed when you open the resource.(-1=not installed)
(Only in the special case where you have a centralized video router which also allows you to commute serial ports, set the data referred to above to 422)