Introduction
The Ross XPression is a crawl generator empowered with a protocol Chyron Intelligent Interface.
Parameters
The information displayed in the first part is merely descriptive and shows previously assigned data:
•Code: It's the path of the resource that you are editing is displayed
•Type: It shows the resource type (e.g., LOGO)
•Number: It indicates the ordinal number that identifies that resource in case others of the same type coexist.
The user must enter the following information:
•Name: Enter a brief description of the resource you are editing.
•Driver: It's fixed for the Ross Video type, XPRESSION,
•IP address: Insert the IP address of the Xpression, its Local Port (default is 9090) and its Config type (0=use one output channel, 1=use two output channels),
•Configuration:
- Logo generator configured as Indicate the way the logo has to be configured (by default, leave this parameter empty),
- Enter the connected DSK: Indicate whether the DSK is internal (INSIDE) or if one of those in the resources (previously configured) must be connected.
(Warning: you must configure DSKs first because only installed DSKs are displayed).
•Preset/Take Mode: Some devices can pre-load the logo before sending it ON AIR in such a way as to speed up the operation at the moment of the take.
This possibility can be done using preset/take mode instead of standard mode. The preset/take mode is suggested only if a commutation is used for each event; otherwise, the results could be unpredictable.
Xpression resource editor - User
Indicate which user and the Etere module will be allowed to use the resource.